Liquid Nails has become synonymous with high performance, premium products. Liquid Nails is the #1 brand of construction adhesive. Contractors continually choose the Liquid Nails line of adhesives when they are looking for outstanding performance. Liquid Nails adhesives out-perform with superior bonding, water resistance, low odor, and can stand up to any tough conditions.
This interior-use, high performance, rubber-based product will bond to almost any common building material including plywood, hardboard, prefinished panels of brick veneer, drywall, fiberglass, aluminum, polystyrene foam insulation and ceramic fixtures. This waterproof product offers up to 10 minutes of working time and twice the strength, exceeding 350 psi, of most similar class adhesives.
America's #1 brand
Original formula
Strong, durable bond
Bonds most common building materials
Bond remains flexible
Adhesive can bridge gaps up to 3/8"
Recommended For: bonding all common building materials, including plywood, hardboard, furring strips, paneling, ceramic fixtures, drywall, molding, and corkboard. NOT Recommended For: application of wood flooring, subfloors, underlayment, ceiling tiles, 1/8" MDF paneling, natural or synthetic marble or granite, fasteners Surface Preparation-Make sure that all surfaces are clean, dry and structurally sound before this construction adhesive is applied. Product Application-Cut and pre-fit materials prior to installation. Insert LIQUID NAILS construction adhesive cartridge into standard caulk gun. Cut nozzle to desired bead size marked on nozzle. Puncture inner seal with nail or wire. Bonding Paneling to Furring Strips or Studs-Apply a zig-zag 1/4" (.64 cm) bead of adhesive to each strip or stud to be covered by material. Position paneling so edges meet at center of stud. Only severely warped materials will require finishing nails at top and bottom. Bonding Panels, Corkboard, etc. to Flat Surfaces-Apply 1/4" (.64 cm) beads of construction adhesive a maximum of 12" (30 cm) apart, within 1-1/2" (3 cm) of all edges and at outside edges. Venting Method-Press materials firmly into place. Pull away for 3 to 5 minutes, then press back into place. Cleanup-Use mineral spirits to clean up both wet and dry construction adhesive.