Stock Status: Call For Stock(shipping delay possible) Average lead time for this brand: less than a week. Specific products may vary.
* Please log into your account to avoid entering this information every time.
ITEM #: 14851591 One simple toggle switches between static water level and drawdown measurements! This meter not only allows accurate depth to water measurements in wells, boreholes, standpipes and tanks, but the drawdown function allows you to monitor falling hydraulic head during low flow sampling, pumping and other aquifer/well tests. It also ensures a pump’s intake remains submerged during purging or well development. The 101D Water Level DrawDown Meter uses a corrosion-resistant stainless steel probe...
ITEM #: 14851591 One simple toggle switches between static water level and drawdown measurements! This meter not only allows accurate depth to water measurements in wells, boreholes, standpipes and tanks, but the drawdown function allows you to monitor falling hydraulic head during low flow sampling, pumping and other aquifer/well tests. It also ensures a pump’s intake remains submerged during purging or well development. The 101D Water Level DrawDown Meter uses a corrosion-resistant stainless steel probe connected to clearly marked flat tape, fitted on a well-designed reel. It is powered by a standard 9 volt battery. In water level mode, when the zero point on the probe enters water, an electronic circuit is completed, activating the buzzer and light. The depth to water is then read off the tape. In drawdown mode, the circuit is reversed— the buzzer and light are triggered when the probe is in air. The battery test button can check the circuit in both water level and drawdown modes. The on/off sensitivity control allows the buzzer to be turned down in cascading water and ensures a clear signal in high and low conductivity conditions.